Elektra Microcasa Semiautomatica Espresso Machine Warranty and Safety Guidelines
- Warranty Note: Please note that it is very important to use ‘softened water’ in these machines, as well as all espresso machines. Hard water will cause these machines to malfunction, and Elektra will not cover the parts warranty due to hard water. In addition, it is extremely important to run the Semiautomatica machines with water at least 25% full in the sight glass. Running these models with a water level lower than this can cause heating element damage which will not be covered under warranty as this is not a manufacturer’s defect. If you return the unit with a damaged heating element, you will be charged for the repair, and the repair charge will be deducted from the credit.
- The exterior color, which includes a clear coat finish, will naturally change as each each Elektra machine ages. The inside of the water reservoir will discolor with the use of hard water (high in magnesium and/or calcium) or distilled/purified water. These items would not be covered under warranty as they are not considered manufacturer’s defects.
- The water in the boiler is not used to make coffee. The water to make coffee comes directly from the reservoir and passes through a pipe in the bottom boiler for flash heating. If cold water passes through this pipe, the change in temperature will cause the boiler water (sight glass) to fluctuate. The only time the water level in the sight glass should change is when
- There is a safety feature on this machine when water is not pumped into the boiler on initial startup. If this isn’t performed correctly, the safety kicks off and the machine will have to be reset. On the bottom of the machine underneath the yellow cap there is a reset button for the safety thermostat.
- CAUTION: ALL SURFACES ARE HOT AND CAN CAUSE BURNS.
Warning for Elektra Microcasa Semiautomatica Espresso Machine:
Before plugging the machine’s electrical cord into the electrical outlet, please make sure the power switch is in the ‘O” (visible) for off position. Fill the top water reservoir before powering on the machine via the power switch. It is important to depress and hold the boiler refill switch on the left side of the machine immediately after powering up the first time. The sight glass needs to fill up to the 75% full mark before releasing the boiler refill switch. The sight glass needs to be filled a minimum of 25% at all times during the operation to avoid damage to the machine.
General Espresso Machine Warning:
- ELECTRICAL WARNING: To avoid electrical damage to this espresso machine which is not considered a manufacturer's defect, please acquire and install a single-outlet surge suppressor rated at 1080 joules or higher. With the lack of the recommended surge suppressor, the espresso machine can be damaged at the power switch, the electronics, the heating element, the pressurestat, or the wiring inside.
- WATER WARNING: To increase the useful life of and not damage your espresso machine, please use softened water. Softened water is water without calcium and without magnesium, but still has other minerals for espresso extraction. Do not use distilled water, purified water, nor reverse osmosis water as these types of water create oxidation with the metals and cause the same damaging effects as limescale.
- DESCALING WARNING: We do not recommend descaling unless there is an issue with the espresso machine. The reason is that too much descaling can eat away at the metals and gaskets inside an espresso machine.